Abus FU9001 Especificaciones descargar pdf (Pagina 31)

7-31

7.2.3

Receiver

Under Receiver, you can make settings that control the radio receiver of your ABUS wireless alarm system.

To access the Receivers menu option:

1. Select the main menu System as described on page 7-23.

2. In the System menu, press

to go to the Receivers menu option. You see the following on the display:

3. Select and configure the settings in the Receiver menu as follows:

Receiver:

Quick-Key Parameter Default Range

Calibration

During calibration, the radio receiver measures the level of the electromagnetic background

noise. The lower the level, the better the selected installation location. Additionally, the level

set decides the strength of the electromagnetic field above which the alarm system

interprets this as a conscious tamper attempt.

Range of level: 00-99.

Press

. The following appears on the display and specifies the current level:

To conduct a new automatic measurement, press and select [Y] YES.

After measurement is complete, the new level is displayed as follows:

To confirm the new level, press

OR:

to change the level manually, enter the desired level and press

NOTES:

To ensure that a measured low value (due to the environment) does not trigger a fault alarm

in later operation, you can set the level higher as the measured value. Never reduce the

measured level, since this will lead to a fault alarm in later operation.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 100 101

Sin comentarios

Abus FU9001 Especificaciones Pagina 31