Abus FU9001 Especificaciones descargar pdf (Pagina 48)

7-48

Force Arm

The Force Arm setting for a zone enables the system to be activated even if one

or more zones are open, provided these zones were programmed with this setting.

• If such a zone is open, the “ready” system LED flashes.

• After the system is activated, all open zones programmed as Force Arm are

automatically excluded from monitoring.

• If such a zone is closed in active status, it is returned to monitoring.

To program a zone with the Force Arm setting:

1. Under Parameters, press

to access the Force Arm menu option. You see the

following on the display:

2. Enter the zone number for which you want to program for Forced Arming and press

3. Press

or to select Enable or Disable and then press .

Repeat steps 1 to 3 to program this settings for the other zones.

Press to exit the menu option.

7.3.3

Zone Testing

Under Testing, you can check the correct functioning of zones.

To access the Testing menu:

1. Select the Zones menu as described on page 7-37.

2. In the Zones menu, press

to access the Testing menu option. You see the following on the display:

Wireless Communication Test

Runs a communication test between the wireless detector and the ABUS wireless

alarm system.

1. Press

. You see the following on the display:

2. To run the communication test, trigger the detector. If reception is successful, the

alarm system shows the signal strength. A successful test is confirmed by a beep

on the alarm system.

NOTE:

For successful communication, the signal strength (= displayed value) should be

higher than the noise level of the transmitter (see also page Calibration).

3. Press

or to select the zone number of the next wireless detector.

4. Press

to exit the menu option.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 100 101

Sin comentarios

Abus FU9001 Especificaciones Pagina 48